Connecting to diginetwork
I (49) wifi: wifi driver task: 3ffb5784, prio:23, stack:3584, core=0
I (295) wifi: wifi firmware version: 0c3a77a
I (295) wifi: config NVS flash: enabled
I (295) wifi: config nano formating: disabled
I (296) wifi: Init dynamic tx buffer num: 32
I (300) wifi: Init data frame dynamic rx buffer num: 32
I (305) wifi: Init management frame dynamic rx buffer num: 32
I (310) wifi: Init management short buffer num: 32
I (315) wifi: Init static rx buffer size: 1600
I (319) wifi: Init static rx buffer num: 10
I (323) wifi: Init dynamic rx buffer num: 32
I (397) wifi: mode : sta (24:6f:28:de:41:70)
I (399) wpa: WPA2 ENTERPRISE VERSION: [v2.0] enable

MAC address: 24:6F:28:DE:41:70
..I (1731) wifi: n:11 0, o:1 0, ap:255 255, sta:11 0, prof:1
..I (2656) wifi: state: init -> auth (b0)
I (2665) wifi: state: auth -> assoc (0)
I (2680) wifi: state: assoc -> run (10)
I (2681) wpa: wpa2_task prio:2, stack:6656

.E (2941) wpa: Method private structure allocated failure

/*
*  This example shows how to use WPA2 enterprise
*  Written by: Jeroen Beemster
*  12 July 2017
*  Version 1.00
*/

#include "esp_wpa2.h"
#include "esp_wifi.h"
#include <WiFi.h>

const char* ssid = "****"; // your ssid
#define EAP_ID "username"
#define EAP_USERNAME "username"
#define EAP_PASSWORD "password"

int  counter = 0;

void setup() {

    esp_log_level_set("*", ESP_LOG_DEBUG);

    Serial.begin(115200);
    delay(10);

    Serial.println();
    Serial.print("Connecting to ");
    Serial.println(ssid);


    // WPA2 enterprise magic starts here
    WiFi.disconnect(true);     
    WiFi.mode(WIFI_STA); //init wifi mode
    esp_wifi_sta_wpa2_ent_clear_ca_cert();
    esp_wifi_sta_wpa2_ent_set_identity((uint8_t *)EAP_ID, strlen(EAP_ID));
    esp_wifi_sta_wpa2_ent_set_username((uint8_t *)EAP_USERNAME, strlen(EAP_USERNAME));
    esp_wifi_sta_wpa2_ent_set_password((uint8_t *)EAP_PASSWORD, strlen(EAP_PASSWORD));
    esp_wpa2_config_t config = WPA2_CONFIG_INIT_DEFAULT(); //set config settings to default
    esp_wifi_sta_wpa2_ent_enable(&config); //set config settings to enable function
    // WPA2 enterprise magic ends here

    esp_wifi_set_storage(WIFI_STORAGE_RAM);

    Serial.print("MAC address: ");
    Serial.println(WiFi.macAddress());

    WiFi.begin(ssid);

    while (WiFi.status() != WL_CONNECTED) {
        delay(500);
        Serial.print(".");
    }

    Serial.println("");
    Serial.println("WiFi connected");
    Serial.println("IP address: ");
    Serial.println(WiFi.localIP());

}